Zhangjian Zhouand Changchun Ge, Fabrication of metal/metal functionally graded materials with a high melting point difference, J. Univ. Sci. Technol. Beijing, 12(2005), No. 5, pp. 427-430.
Cite this article as:
Zhangjian Zhouand Changchun Ge, Fabrication of metal/metal functionally graded materials with a high melting point difference, J. Univ. Sci. Technol. Beijing, 12(2005), No. 5, pp. 427-430.
Zhangjian Zhouand Changchun Ge, Fabrication of metal/metal functionally graded materials with a high melting point difference, J. Univ. Sci. Technol. Beijing, 12(2005), No. 5, pp. 427-430.
Citation:
Zhangjian Zhouand Changchun Ge, Fabrication of metal/metal functionally graded materials with a high melting point difference, J. Univ. Sci. Technol. Beijing, 12(2005), No. 5, pp. 427-430.
Laboratory of Special Ceramics & Powder Metallurgy, Materials Science and Engineering School, University of Science and Technology Beijing, Beijing 100083, China
Three kinds of full compositional distribution (from 0 to 100wt%W) W/Cu FGMs (functionally graded materials) with high density is fabricated by resistance sintering under ultra-high pressure. Microstructure analysis showed that the good grading composition of all FGMs has been obtained. The sintering mechanism of W is mainly solid state sintering. Thermal shock test in air demonstrated that the grading at the interface between W and Cu is effective for the reduction of thermal stress, but obvious transverse and vertical cracks occur in the pure W layer. The oxidation of the W60Cu40 layer and the W40Cu60 layer is heavier than that of the other layers.
Search
DownLoad: