Yanli Wang, Zhi Lin, Junpin Lin, Xinfa Cui, and Guoliang Chen, Determination of plastic equation of state by indentation method on 304 stainless steel, J. Univ. Sci. Technol. Beijing, 12(2005), No. 2, pp. 151-154.
Cite this article as:
Yanli Wang, Zhi Lin, Junpin Lin, Xinfa Cui, and Guoliang Chen, Determination of plastic equation of state by indentation method on 304 stainless steel, J. Univ. Sci. Technol. Beijing, 12(2005), No. 2, pp. 151-154.
Yanli Wang, Zhi Lin, Junpin Lin, Xinfa Cui, and Guoliang Chen, Determination of plastic equation of state by indentation method on 304 stainless steel, J. Univ. Sci. Technol. Beijing, 12(2005), No. 2, pp. 151-154.
Citation:
Yanli Wang, Zhi Lin, Junpin Lin, Xinfa Cui, and Guoliang Chen, Determination of plastic equation of state by indentation method on 304 stainless steel, J. Univ. Sci. Technol. Beijing, 12(2005), No. 2, pp. 151-154.
An indentation method for determining the plastic mechanical equation of state (PES) was studied. The constant loading rate and constant loading rate/load indentation tests were carried out. The method for determining the work-hardening coefficient and the strain rate sensitivity coefficient of PES were discussed in detail. 304 stainless steel hot-treated at 1100°C was used to verify the method. The work-hardening coefficient and strain rate sensitivity coefficient of 304 stainless steel were respectively determined as 0.30 and 0.015. These values are very close to those achieved by tensile tests. From the establishment of the PES of 304 stainless steel it is shown that the PES obtained by the indentation method is easier than that by the tensile test.
An indentation method for determining the plastic mechanical equation of state (PES) was studied. The constant loading rate and constant loading rate/load indentation tests were carried out. The method for determining the work-hardening coefficient and the strain rate sensitivity coefficient of PES were discussed in detail. 304 stainless steel hot-treated at 1100°C was used to verify the method. The work-hardening coefficient and strain rate sensitivity coefficient of 304 stainless steel were respectively determined as 0.30 and 0.015. These values are very close to those achieved by tensile tests. From the establishment of the PES of 304 stainless steel it is shown that the PES obtained by the indentation method is easier than that by the tensile test.
下载: