Maicang Zhang, Jianxin Dong, Yanping Zeng, and Xishan Xie, A phenomenological constitutive equation for Rene 95 PM alloy and its application to isothermal forging process of turbine disk, J. Univ. Sci. Technol. Beijing, 9(2002), No. 4, pp. 282-286.
Cite this article as:
Maicang Zhang, Jianxin Dong, Yanping Zeng, and Xishan Xie, A phenomenological constitutive equation for Rene 95 PM alloy and its application to isothermal forging process of turbine disk, J. Univ. Sci. Technol. Beijing, 9(2002), No. 4, pp. 282-286.
Maicang Zhang, Jianxin Dong, Yanping Zeng, and Xishan Xie, A phenomenological constitutive equation for Rene 95 PM alloy and its application to isothermal forging process of turbine disk, J. Univ. Sci. Technol. Beijing, 9(2002), No. 4, pp. 282-286.
Citation:
Maicang Zhang, Jianxin Dong, Yanping Zeng, and Xishan Xie, A phenomenological constitutive equation for Rene 95 PM alloy and its application to isothermal forging process of turbine disk, J. Univ. Sci. Technol. Beijing, 9(2002), No. 4, pp. 282-286.
The flow behavior of Rene 95 PM alloy was studied from 1050 to 1150℃ with strain rate of 1×10-3, 1×10-2, 1×10-1 and 1s-1. At a given temperature and strain rate, flow curves exhibit a peak followed by flow softening up to a steady state. Moreover, at constant strain, flow stress increases with increasing strain rate and decreasing temperature. An equation relating hyperbolic sine of flow stress to hot working parameters, such as strain, strain rate and temperature, was established by using multiple nonlinear regression method. A very good agreement was found between predicted and experimental flow stress in all the strain range investigated. Application of the constitutive equation in predicting forming loads and flow behavior and temperature distribution in both upper and lower dies in an isothermal forging process of turbine disk of large dimension (about 630mm) by means of a finite element code was systematically analyzed.
The flow behavior of Rene 95 PM alloy was studied from 1050 to 1150℃ with strain rate of 1×10-3, 1×10-2, 1×10-1 and 1s-1. At a given temperature and strain rate, flow curves exhibit a peak followed by flow softening up to a steady state. Moreover, at constant strain, flow stress increases with increasing strain rate and decreasing temperature. An equation relating hyperbolic sine of flow stress to hot working parameters, such as strain, strain rate and temperature, was established by using multiple nonlinear regression method. A very good agreement was found between predicted and experimental flow stress in all the strain range investigated. Application of the constitutive equation in predicting forming loads and flow behavior and temperature distribution in both upper and lower dies in an isothermal forging process of turbine disk of large dimension (about 630mm) by means of a finite element code was systematically analyzed.
下载: