Cite this article as:

Huixiang Yu, Dexin Yang, Jiaming Zhang, Guangyuan Qiu, and Ni Zhang, Effect of Al content on the reaction between Fe−10Mn−xAl (x = 0.035wt%, 0.5wt%, 1wt%, and 2wt%) steel and CaO−SiO2−Al2O3−MgO slag, Int. J. Miner. Metall. Mater., 29(2022), No. 2, pp.256-262. https://dx.doi.org/10.1007/s12613-021-2298-y
Huixiang Yu, Dexin Yang, Jiaming Zhang, Guangyuan Qiu, and Ni Zhang, Effect of Al content on the reaction between Fe−10Mn−xAl (x = 0.035wt%, 0.5wt%, 1wt%, and 2wt%) steel and CaO−SiO2−Al2O3−MgO slag, Int. J. Miner. Metall. Mater., 29(2022), No. 2, pp.256-262. https://dx.doi.org/10.1007/s12613-021-2298-y
shu
引用本文 PDF XML SpringerLink

Al含量对Fe−10Mn−xAl (x = 0.035wt%, 0.5wt%, 1wt%, 2wt%)合金体系和CaO−SiO2−Al2O3−MgO精炼渣反应的影响

摘要: 轻量化是世界汽车发展的方向，中高锰钢因高强、高塑、高加工硬化率等优异的力学性能引起了人们的很大关注。除Mn含量高外，该钢种通常含有较高的Al以降低材料密度、防止氢延迟断裂等。因合金含量高，钢液中的溶质元素和顶渣会发生较强的渣/钢反应，进而对钢液、顶渣、洁净度等产生重要影响。本文旨在研究不同Al含量的中锰钢与精炼渣的反应及其影响。本文采用渣/钢平衡的实验方法研究了不同Al 含量(0.035wt%, 0.5wt%, 1wt%, 2wt%)的Fe−10Mn−xAl 合金体系与CaO−SiO2−20wt%Al2O3−6wt%MgO (CaO/SiO2 = 4)精炼渣之间的反应，及其对钢液和炉渣成分、非金属夹杂物的影响；在实验基础上，对钢液和炉渣成分变化以及夹杂物转变进行了热力学分析与讨论。研究结果表明，渣/钢反应后，钢中Al含量显著降低，初始Al含量对反应后钢、渣的成分有重要影响。随着初始Al含量增加，钢中的Si和渣中的Al2O3逐渐增加，而渣中的SiO2和MnO逐渐减少。造成该变化的原因是：随着初始Al含量增加，钢液中的Al逐渐替代Mn与渣中SiO2反应，即渣/钢之间的主控反应由2Mn + (SiO2) = 2(MnO) + Si转变为4Al + 3(SiO2) = 2(Al2O3) + 3Si。随着初始Al含量增加，钢中夹杂物类型也发生很大变化，转变路线为：MnO → MnO−Al2O3−MgO → MgO → MnO−CaO−Al2O3−MgO 和 MnO−CaO−MgO，相应的夹杂物形状由球形变为不规则状，最后又变为类球形。其转变机理是：随着初始Al含量增加，钢中Al逐渐替代Mn与渣中SiO2反应，且Mg、Ca依次从渣中还原进入钢液，故而夹杂物类型发生上述转变。

 

Effect of Al content on the reaction between Fe−10Mn−xAl (x = 0.035wt%, 0.5wt%, 1wt%, and 2wt%) steel and CaO−SiO2−Al2O3−MgO slag

Abstract: The effect of Al content (0.035wt%, 0.5wt%, 1wt%, and 2wt%) on the composition change of steel and slag as well as inclusion transformation of high manganese steel after it has equilibrated with CaO−SiO2−Al2O3−MgO slag was studied using the method of slag/steel reaction. The experimental results showed that as the initial content of Al increased from 0.035wt% to 2wt%, Al gradually replaced Mn to react with SiO2 in slag to avoid the loss of Mn due to the reaction; this process caused both Al2O3 in slag and Si in steel to increase while SiO2 and MnO in slag to reduce. In addition, the type of inclusions also evolved as the initial Al content increased. The evolution route of inclusions was MnO → MnO−Al2O3−MgO → MgO → MnO−CaO−Al2O3−MgO and MnO−CaO−MgO. The shape of inclusions evolved from spherical to irregular, became faceted, and finally transformed to spherical. The average size of inclusions presented a trend that was increasing first and then decreasing. The transformation mechanism of inclusions was explored. As the initial content of Al increased, Mg and Ca were reduced from top slag into molten steel in sequence, which consequently caused the transformation of inclusions.

 

    HTML全文
    • 资源附件(0)

    • 参考文献(31)

    参考文献(31)
    • 相关文章
    施引文献

/

返回文章
返回